[Chevelle-list] Chevelle-list Digest, Vol 42, Issue 19

[Jim Sullivan]

I get such a laugh out of this no matter how many times I have seen it.

  ----- Original Message ----- 
  From: Z16CHEVELLEGUY at aol.com 
  To: chevelle-list at chevelles.net 
  Cc: Nova1093 at cs.com 
  Sent: Sunday, January 14, 2007 9:50 PM
  Subject: Re: [Chevelle-list] Chevelle-list Digest, Vol 42, Issue 19


    
  Mr Nova Guy:
  Why don't you read this and maybe then you can figure out why you are getting this email.
  This is a reminder, sent out once a month, about your chevelles.net
  mailing list memberships.  It includes your subscription info and how
  to use it to change it or unsubscribe from a list.

  You can visit the URLs to change your membership status or
  configuration, including unsubscribing, setting digest-style delivery
  or disabling delivery altogether (e.g., for a vacation), and so on.

  In addition to the URL interfaces, you can also use email to make such
  changes.  For more info, send a message to the '-request' address of
  the list (for example, mailman-request at chevelles.net) containing just
  the word 'help' in the message body, and an email message will be sent
  to you with instructions.
  Chevelle-list at chevelles.net              chevelle  
  http://chevelles.net/mailman/options/chevelle-list_chevelles.net

  If you have questions, problems, comments, etc, send them to
  mailman-owner at chevelles.net.  Thanks!
  Or 
  To unsubscribe from this service you must first 
  purchase a 
  Craft-O-Matic Adjustable Subscription Cancellation 
  Unit. The unit can be 
  obtained from most hardware stores and dental clinics. 
  Be sure to obtain the proper permits to operate the 
  unit from the 
  Nuclear Regulatory Commission and the Food and Drug 
  Administration in 
  Washington D.C. USA. 
  Be sure to carefully unpack the kit and place each 
  component in its 
  accompanying mesh safety bag. 
  Mount the Pershing DF4 mesinator on top of the 
  perforated Gerring Mach 
  77 refibulator and attach them using the 
  eight-millimeter torque fork. 
  Be sure that the refibulator is mounted at a 66 degree 
  angle and 
  properly dispersed so that it is flush with the curved 
  section of the 
  Pyrex thistle tube. 
  Place the four sections of the triangular separation 
  gear into the 
  posture cylinder and lock them into place using the 
  band aid adhesive strip. 
  Insert the wiggling pin into the wobbling hole, making 
  sure that it 
  seated correctly. 
  Place the D cell battery and the eleven 9 volt 
  batteries in the power 
  chamber. 
  The device should be calibrated before operation using 
  the optional 
  digital corkscrew accessory pack prior to operation. 
  Insert the digital corkscrew through the electronic 
  combustion service 
  chamber using caution not to touch the reinforced 
  tungsten igniter 
  control module and quickly turn the inverter drive to 
  28.6 degrees. 
  Turn the Craft-O-Matic Adjustable Subscription 
  Cancellation Unit upside 
  down and hit the bottom plate with a 48-ounce 
  ball-peen hammer while 
  shaking the unit vigorously. 
  Force open the door to the incineration valve 
  compartment and set the 
  pressure gauge to 719 psi. 
  Close the door and seal it shut with duct tape. 
  The unit should now be properly calibrated and ready 
  to use. 
  Before activating the Craft-O-Matic Adjustable 
  Subscription 
  Cancellation Unit, you must first elevate it to a 
  height of 229 feet 
  above sea level to insure that the unit receives the 
  proper oxygen level 
  and barometric pressure. 
  Point the aerial to 17 degrees north by northeast to 
  within the 
  parameters of the Telstar GS-2 weather satellite and 
  apply pressure to 
  the wing shaft on the southern most section of the 
  modular accelerator. 
  Using the special ratchet adapter supplied with the 
  unit, rotate the 
  heater core to the "on" position. The "on" position 
  has been obtained 
  when the green light begins to flash, signifying that 
  the red light is 
  about to go off. 
  Once the red light is off, flip the toggle switch 
  labeled "ON/OFF" to 
  the "ON" position and count to 47 before logging on to 
  the system. 
  Logon using your username and password and wait for 
  the prompt. 
  Once prompted you must check the box with the 
  appropriate action you 
  wish to take and then press the pressure release 
  button and turn off the 
  compressor while turning the hand crank at 231 meters 
  per minute. 
  Next, press control, alt, delete, caps lock, shift, 
  number lock, escape 
  and tab simultaneously. 
  Press enter. You will have one second to complete the 
  procedure. 
  If you fail to respond in the time limit allowed, 
  simply purchase a new 
  Craft-O-Matic Adjustable Subscription Cancellation 
  Unit and start from 
  the beginning. 
  Please remember that this is the only way we will 
  accept for you to 
  unsubscribe from this service. 
  We have made every attempt to simplify the procedure 
  for your 
  convenience. Failure to comply with the unsubscribe 
  policy will result 
  in immediate termination of your subscription so 
  please follow the above 
  directions closely 

  Regards 

  The Chevelle List
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://chevelles.net/pipermail/chevelle-list_chevelles.net/attachments/20070114/f843f883/attachment.html