[Chevelle-list] 12 Bolt Spider Gear Washer

[dansolomon at msn.com]

I wish it was that easy. It is a posi. The only way I can do that would be to remove the clutch.

Godspeed,
Dan Solomon
It is a mistake to allow any mechanical object to realize you are in a hurry.
http://www.freewebs.com/chevelles1970/

-----Original Message-----
From: "Jim H. Thompson" <jimthompsoncc at gmail.com>

Date: Wed, 5 Dec 2007 18:08:43 
To:"'The Chevelle Mailing List'" <chevelle-list at chevelles.net>
Subject: Re: [Chevelle-list] 12 Bolt Spider Gear Washer


You need to pull the center pin. Spin the internals around until you get the spider gear you want at the opening. Slip in the washer and spin it back around. 
  
 
 
From: chevelle-list-bounces at chevelles.net [mailto:chevelle-list-bounces at chevelles.net] On Behalf Of Daniel Solomon
 Sent: Saturday, December 01, 2007 3:25 PM
 To: The Chevelle Mailing List
 Subject: [Chevelle-list] 12 Bolt Spider Gear Washer 
  
I pulled the axles out of my GM 12 Bolt with Eaton Posi in preparation for an upcoming swap and one of the cupped washers fell out from behind a spider gear. I found it in the bottom of the case. It came out... So you would think it would go back in... For the life of me I can't figure it out.
 Do I need to pull out the clutch? I have tried and walked away three different times. Anyone else out there had this happen? Any ideas that will help a poor old 10-Bolter?
 
 Godspeed, Dan Solomon
 "It is a mistake to allow any mechanical object to realize you are in a hurry."
 http://www.freewebs.com/chevelles1970/ <http://www.freewebs.com/chevelles1970/>