[Chevelle-list] Trimming the framerail, what cutter?

[Josh Egler]

I agree totally, a plasma cutter will make this only a few minute job.  I
also installed a tank from a 95 Caprice

Josh

On 8/28/07, Dan at Earthlink <danmcintosh at earthlink.net> wrote:
>
>  If you have access to a plasma cutter, by all means, use that.  If you do
> not, then use a cut off wheel on a 4 1/2" grinder.  Wear goggles!
>
> Dan McIntosh
> Street Metal Fabrications
> http://www.lowriderimpala.com
>
>
>
> ----- Original Message -----
> *From:* the.cat at codding.org
> *To:* The Chevelle Mailing List <chevelle-list at chevelles.net>
> *Sent:* Monday, August 27, 2007 11:29 PM
> *Subject:* [Chevelle-list] Trimming the framerail, what cutter?
>
> -----BEGIN PGP SIGNED MESSAGE-----
> Hash: SHA1
>
> Hiya,
>
> I'm installing a fuel tank from a 95 Caprice as part of my engine swap,
> and I need to cut 3/4" off each lower framerail to do it. What's the
> best tool to use?
>
> Dave.
> -----BEGIN PGP SIGNATURE-----
> Version: GnuPG v1.2.4 (Darwin)
>
> iD8DBQFG05ajrFe9ZwWo2/kRAudaAJ9wYwctQa6+qA3lLofEbCU6RRvHmgCfZdmg
> vcbaNEU/eGb9TiUYfcsVrkw=
> =RHEZ
> -----END PGP SIGNATURE-----
>
>
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.5.484 / Virus Database: 269.12.9/975 - Release Date: 8/26/2007
> 9:34 PM
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://chevelles.net/pipermail/chevelle-list_chevelles.net/attachments/20070828/700c0ce2/attachment.html