[Chevelle-list] Fender-Door Gap Adjustment

[Dave Benjamin]

I have had to Space up the rad support before. Not sure if it was a body, rad mount problem or if the car got bent?

Dave
Ingersoll,Ontario
My Web Site: http://members.tripod.com/benj30/
  ----- Original Message ----- 
  From: Rick Schaefer 
  To: chevelle-list at chevelles.net 
  Sent: Tuesday, August 14, 2007 2:37 PM
  Subject: [Chevelle-list] Fender-Door Gap Adjustment


      I'm finally getting round to try to even out the door to fender gap on my 72 elky.   Both sides are equally bad, a good gap at the bottom & then widen out significantly at the top.     I believe that the doors are hung straight because the door to rear quarter panels have an even gap.     Pictures are at link below.    

  http://www.flickr.com/photos/9912293@N08/sets/72157601417827062/

  It appears to me that the same adjustment is out of whack on both sides, but which one?    I've never messed with the panels so want to get some advice before I loosen the fenders.  

   Is it possible that frame sag is pulling the front of both fenders in?   The body & core support bushings were replaced with poly about 10 years ago.  Honestly I don't remember if I had the problem before it was painted (years ago also).  Painter did take the fenders & doors offback then.  
  thank you.
  -- 
  Rick Schaefer
  72 TPI El Camino

   


------------------------------------------------------------------------------


  No virus found in this incoming message.
  Checked by AVG Free Edition. 
  Version: 7.5.476 / Virus Database: 269.11.17/951 - Release Date: 8/13/2007 10:15 AM
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://chevelles.net/pipermail/chevelle-list_chevelles.net/attachments/20070815/bd24811e/attachment.html