[Chevelle-list] Manifold vacuum fitting?

[Karl Groves]

Just to add a little info:
As Carl said, the fitting pictured is for the trans. The fitting will
probably go in the rear-passenger side of the manifold.
The fitting for the brakes is MUCH bigger around. As Carl said, it'll come
off the back of the carb and will be about 1/2inch in diameter
 
Pelle - 
Getting these wrong (and leaving them unplugged) might be contributing to
your poor idle issues.

Karl Groves
Master Certified CIW
http://www.karlgroves.com <http://www.karlgroves.com/> 

Grayscale Content Management System:
http://www.grayscalecms.com <http://www.grayscalecms.com/> 

Independent Musician's Handbook:
http://www.indiebook.com <http://www.indiebook.com/> 



 


  _____  

From: Carl Ziegler [mailto:zieg72 at yahoo.com] 
Sent: Sunday, September 17, 2006 8:21 PM
To: The Chevelle Mailing List
Subject: Re: [Chevelle-list] Manifold vacuum fitting?


The pictured item is for the vacuum to the trans.  It typically has a hard
steel line that goes into that fitting with a short piece of rubber hose to
make the seal.  The power brakes are off the back of the carb on bottom, at
least that is the way my 72 is.


-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://chevelles.net/pipermail/chevelle-list_chevelles.net/attachments/20060917/29d18f1a/attachment.htm