[Chevelle-list] Best primer - frame/ suspension parts

[Dan McIntosh]

Epoxy Primer is your best bet on bare metal, whether its your frame, or your sheetmetal.  All bodywork should be done on top of the epoxy primer.

You can pick up a cheap gravity feed gun at Harbor Freight for about 15 bucks that will work great for spraying your frame and suspension.

Best of luck!

Dan McIntosh
90'd out 1983 Fleetwood Coupe 
Street Metal Fabrications
http://www.lowriderimpala.com
  ----- Original Message ----- 
  From: Karl Groves 
  To: 'The Chevelle Mailing List' 
  Sent: Thursday, September 07, 2006 11:34 PM
  Subject: [Chevelle-list] Best primer - frame/ suspension parts


  With the rotisserie almost done, I'm within a week or two of taking my body
  off the frame.
  I plan on sanding/ sandblasting it down as well as removing, sanding/
  sandblasting all the suspension stuff as well. 
  My question is, what sort of primer should I use on these parts?  Because of
  where I am doing this (outside, not in an enclosed area), I'd prefer to use
  a rattle can, but if that's not going to yield good results, I'll do what I
  have to do (and I have a compressor and an HVLP gun).

  Anyone have any advice on this?


  Karl Groves
  Master Certified CIW
  http://www.karlcore.com 

  Will Work For Parts:
  http://chevelle.karlcore.com/detail.php?id=3




  -- 
  No virus found in this incoming message.
  Checked by AVG Free Edition.
  Version: 7.1.405 / Virus Database: 268.12.1/440 - Release Date: 9/6/2006

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://chevelles.net/pipermail/chevelle-list_chevelles.net/attachments/20060908/dcf91e6a/attachment.htm