[Chevelle-list] Spindle

[Jim H. Thompson]

It does not go all the way down, the shaft is tapered. Tork it to 40 lbs and
put the cotter pin in.

-----Original Message-----
From: chevelle-list-bounces at chevelles.net
[mailto:chevelle-list-bounces at chevelles.net]On Behalf Of langus
Sent: Tuesday, October 10, 2006 5:53 PM
To: Chevelle Chat Forum
Subject: [Chevelle-list] Spindle

I was just trying to replace my front coil springs but ran into a snag when
I couldnt get the new lower ball joint stud to slide all the way through the
hole in the spindle.  I recall having to use a ball joint seperator to get
them apart the first time.  Is there a trick to getting it all the way down
on the stud so I can get the castle nut seated enough to get the pin back
in?  Thanks for the help


Ryan
-------------- next part --------------
An HTML attachment was scrubbed...
URL: /pipermail/chevelle-list_chevelles.net/attachments/20061011/91722f87/attachment.html